S10/T10 P/U 2WD V6-262 4.3L (1988)
6.
Spray entire prepared area with a coat of DP40/DP401 anti-corrosion primer (PPG/ Ditzler) or equivalent. Follow manufacturers instructions and
recommended dry times.
7.
Apply 2 to 3 medium wet coats of primer-surfacer to primed surfaces of truck, making sure to follow manufacturers instructions for application.
8.
After allowing adequate drying time, wet sand with 400 grit (or finer) sandpaper or dry sand with 320 grit (or finer) sandpaper.
9.
Repeat steps 4 and 5.
10.
Apply 1 medium wet coat of primer sealer, following manufacturers instructions.
11.
Apply 3 to 4 medium wet coats (or until primer color is well hidden) of Acrylic/Urethane Enamel Color. Follow manufacturers instructions.
NOTICE:
Reinstall all trim and other items removed in step 2.
12.
Final wash and detail vehicle.
Claim Information
Submit a claim with the information indicated below:
*
Select times as listed below for "Labor Hours" and material allowances for "Net Amount" as required for appropriate vehicle type and
operation performed.
