S10/T10 P/U 2WD V6-262 4.3L (1988)
Steering Gear: Service and Repair
Removal/Installation
1.
On models equipped with power steering, disconnect pressure and return hoses from steering gear housing, then plug hose ends and gear
housing ports to prevent entry of dirt.
2.
On all models, disconnect battery ground cable and remove coupling shield if so equipped.
3.
Remove retaining nuts, lock washers and bolts at steering coupling to steering shaft flange.
4.
Remove pitman arm nut and washer from pitman shaft and mark relation of arm position to shaft, then remove pitman arm using a puller.
5.
On turbocharged models, raise and support vehicle.
6.
Remove charge air cooler radiator.
7.
Lower vehicle, then remove intermediate shaft assembly at steering gear.
8.
Remove attaching bolt and nut to pot joint coupling. Ensure alignment marks line up.
9.
On all models, remove screws securing steering gear to frame and remove gear from vehicle.
10.
Reverse procedure to install.
