S10/T10 P/U 2WD V6-262 4.3L (1988)
Window Handle: Service and Repair
Front Door Window Regulator Handle
TOOL REQUIRED:
J-9886-O1, Door Handle Remover.
REMOVE OR DISCONNECT
1. Window regulator handle.
^
Insert J-9886-O1 between the handle and the bearing plate.
^
Align the tool parallel with the door handle, and push to disengage the clip.
^
Pull the handle from the door.
2. Bearing plate.
INSTALL OR CONNECT
1. Bearing plate.
2. Window regulator handle.
^
Place the window in the raised position.
^
Put the clip onto the handle,
^
Insert the handle onto the door so the handle is pointing towards the front of the door.
^
Push on the handle until the clip engages the window regulator shaft.