S10/T10 P/U 2WD V6-262 4.3L VIN W CPI (1992)
-
Apply rubber lubricant to the inside diameter of hose ends, If desired.
-
Slip a new hose clamp over one end of the hose and push the hose onto the heater pipe with a twisting motion.
-
Repeat the hose and clamp installation procedure at the other end of the hose.
-
Tighten clamp screw to 1.7 Nm (15 in. lb.).
4. Engine coolant.
-
Use the coolant drained earlier only if it is uncontaminated. Discard contaminated coolant and add fresh 50/50 coolant and water mixture.
Inspect
-
Be sure the installed hose(s) do not sag or rub against other components. Adjust or support the hose as necessary to correct.
-
Operate the engine and check the hose installation for leaks.
-
Tighten the hose clamp screw a bit at a time, if necessary, to stop a leak.
-
Check the coolant level after the engine has been warmed up and allowed to cool. Add coolant as required.