S10/T10 P/U 2WD V6-262 4.3L VIN W CPI (1992)
-
make sure parts positioning is correct (Figure 3).
b.
Install the link bolt (62) through the lower control arm hole (59) with the parts stacked properly (Figure 3).
-
Grommet (58)
-
Retainer (57)
-
Spacers (56)
-
Retainers (55)
-
Grommet (54)
-
Stabilizer (53)
c.
Attach the grommet (52), retainer (51) and nut (50) on the link bolt (62) (Figure 3) and tighten nut until the nut meets the end of the bolt
threads (62) (Figure 3).
6. Install shock absorber (36) (Figure 2).
a.
Install retainer (35) and grommet (34) on the stem (33) (Figure 2).
-
Fully extend the stem (33).
b.
Install shock absorber (36) up through the lower control arm (40) and the spring (37).
-
Insert the stem (33) end through the hole in the upper control arm frame bracket (42) (Figure 2)
c.
Install the grommet (32), retainer (31), and the nut (30) on to the stem (33) (Figure 2).
Tighten:
Tighten bolt (38) to 27 N-m (20 lbs.ft.).
SERVICE PARTS INFORMATION:
Parts are currently available from GMSPO.
WARRANTY INFORMATION:
For vehicles repaired under warranty, use:
