S10/T10 P/U 2WD V6-262 4.3L VIN Z TBI (1995)
Drive Belt: Service and Repair
Removal and Installation (Without A.I.R. System)
DRIVE BELT REPLACEMENT
Engines Without A.I.R System
Remove or Disconnect
NOTICE: Do not allow the drive belt tensioner to snap into the "free" position. This may result in damage to the tensioner.
1. Use a 1/2-inch breaker bar with a socket placed on the tensioner pulley axis bolt and rotate the tensioner to release belt tension.
2. Belt.
Engines Without A.I.R System
lnstall or Connect
1. Route belt over all the pulleys except the belt tensioner.
2. Use a 1/2-inch breaker bar with a socket placed on the tensioner pulley axis bolt and rotate the tensioner to the released position.
3. Belt over the belt tensioner pulley.
4. Check the belt for correct "V" groove tracking around each pulley.
