S10/T10 P/U 2WD V6-262 4.3L VIN Z TBI (1995)
Procedure B
Bring the engine up to Top Dead Center (TDC) of cylinder number 1. Make sure it is on the compression stroke.
Distributor Alignment Indicators
A. Remove the distributor cap screws and cap to expose the rotor.
B. Align the pre-drilled indent hole in the distributor driven gear with the arrow cast into the upper portion of the shaft housing. The rotor segment
should point to the cap hold down mount nearest the flat side of the housing.
C. Using a long screw driver, align the oil pump drive shaft in the engine in the mating drive tab in the distributor.
D. Guide the distributor into place, making sure the locating slot in the distributor base fits over the dowel pin in the intake manifold. -
Description
