S10/T10 P/U 2WD V6-262 4.3L VIN Z TBI (1995)
Wiper Motor: Service and Repair
1. Disconnect battery ground cable.
2. Remove windshield wiper arms.
3. Remove cowl vent and grille.
4. Loosen, but do not remove transmission drive link to motor crank arm attaching nuts, then disconnect drive link from motor crank arm using wiper
transmission separator tool No. J-39232, or equivalent.
5. Disconnect motor electrical connector and remove attaching bolts.
6. Remove motor by rotating up and outward.
7. Reverse procedure to install, noting the following:
a. Torque motor attaching bolts to 49-75 inch lbs.
b. Install drive link to wiper motor using wiper transmission installer tool No. J39529, or equivalent.
