S10/T10 P/U 2WD V6-4.3L VIN W (1997)
Electronic Brake Control Module: Service and Repair
Tube Adapters
Tube Adapters
REMOVE OR DISCONNECT
1. Disconnect appropriate brake line from tube adapters.
2. Tube adapter.
INSTALL OR CONNECT
1. Tube adapter.
^
Tighten Tube adapter to 31 Nm (23 ft. lbs.)
2. Brake line.
3. Bleed the system. Refer to hydraulic Brake System.
NOTE: If more than one tube adapter is to be removed at one time, the Brake Pressure Modulator Valve (BPMV) should be stamped with a number (1,
2, or 3) to correspond with the number of grooves cut into the tube adapters. This will aid in proper reassembly.