S10/T10 P/U 2WD V6-4.3L VIN W (1997)
10. Lower the vehicle
NOTE: Before moving the vehicle, pump the brake pedal several times. to make sure it is firm. Do not move the vehicle until a firm pedal is
obtained. Check the brake fluid level in the master cylinder after pumping the brakes.
Overhaul
Caliper Components
REMOVE OR DISCONNECT
1. Drain all fluid from caliper.
2. Pad interior of caliper with clean shop towels.
CAUTION: Do not place your fingers in front of the piston in an attempt to catch or protect it when applying compressed air. This could result in
serious injury.
NOTE: Use Just enough air pressure to ease the piston out of the bore. Even with the padding, If the piston Is blown out It can be damaged.
3. Piston.
Removing The Caliper Boot
