S10/T10 P/U 2WD V6-4.3L VIN W (1997)
Description
11. As shown, the number 2 is the rotor mounting holes and the number 1 is the locating holes.
12. Install the two rotor hold down screws.
Tighten
Tighten the screws to 2.5 Nm (25 lb in).
13. Install the distributor in the engine, with the cap off.
14. Install the bolt in the hold down lug.
Tighten
Tighten the bolt to 27 Nm (20 lb ft).
Description
15. Install the distributor cap.
