chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Deployed Inflator Module|Page 9842 > < Deployed Inflator Module|Page 9840
Page 6
background image

^

Do not connect the inflator module to a power source until you are ready to deploy the air bag.

^

The inflator module will immediately deploy when you connect the power source.

19. Clear the area of all people, and any loose or flammable objects.
20. Make sure that you place the inflator module with its vinyl trim cover facing up.
21. Notify all the people in the immediate area before you deploy the inflator module.

^

A driver inflator module deployment is very load.

^

This may startle any uninformed people in the area.

Caution: When you are deploying an inflator module for disposal, perform the deployment procedures in the order listed:

^

Wear safety glasses throughout the procedures.

^

Clear a space on the ground about 1.85 meters (six feet) in diameter where the inflator module will be deployed.

^

Make sure the area around the inflator module is clear of all people and loose or flammable objects.

^

Short the deployment harness wires as instructed

^

Connect the deployment harness to the inflator module before you connect it to the power source.

^

Connect the deployment harness to the power source to immediately deploy the air bag. Failure to follow the procedures in the order
listed may result in personal injury.

Important: The rapid gas expansion involved with deploying an air bag is very load. Notify all the people in the immediate area that you intend to
deploy the inflator module.

Important: When the air bag deploys, the inflator module may jump about 30 cm (1 ft.) vertically. This is a normal reaction of the inflator module to the
force of the rapid gas expansion inside the air bag.

22. Separate the two banana plugs on the SIR deployment harness.

23. Connect the SIR deployment harness wires to the power source. This immediately deploys the inflator module.
24. Use a vehicle battery for the power source when available. Always use a power source that complies to the following:

^

12 volts minimum

^

2 amps minimum

25. Disconnect the SIR deployment harness from the power source.

Deployed Inflator Module|Page 9842 > < Deployed Inflator Module|Page 9840