S10/T10 P/U 2WD V6-4.3L VIN W (1997)
Fog/Driving Lamp Switch: Service and Repair
Remove or Disconnect
-
Make sure the headlamp switch is in the OFF position.
-
Make sure the ignition switch is in the LOCK position.
1. Instrument panel accessory trim plate.
2. Electrical connector.
3. Fog lamp switch from the headlamp switch panel.
-
Squeeze the switch retainers and push the switch out through the front of the switch panel.
Install or Connect
1. Fog lamp switch to the headlamp switch panel.
-
Switch retainers must be fully seated to the switch panel.
2. Electrical connector.
3. Instrument panel accessory trim plate.