S10/T10 P/U 2WD V6-4.3L VIN W (1997)
Engage Stub Shaft
-
Install valve spool (41) to valve body (43) by pushing and rotating until hole in valve spool (41) for stub shaft pin is accessible from opposite
end of valve body (43).
2. Stub shaft (40) to valve spool, if necessary and insert pin.
-
Notch in stub shaft cap must fully engage valve body pin and seat against valve body shoulder.
-
Install O-ring seals (45) and teflon rings (46) to valve body (43).
-
Lubricate O-ring seals (45) and teflon rings (46) with power steering fluid.
3. Stub shaft (40) and valve assembly to worm shaft (13), fitting pin on worm shaft (13) to slot in the valve assembly.
4. Adjuster plug.
ADJUST
-
Thrust bearing preload and pitman shaft overcenter sector.
INSTALL OR CONNECT
-
Steering gear.
Rack Piston and Worm Shaft Replacement
