S10/T10 P/U 2WD V6-4.3L VIN W (1997)
3. Insert spring, small washer, three seats and large washer into housing, thoroughly greasing each part as it is inserted.
4. Place grease seal on housing with seal lip facing down into bore.
5. Place Seal Installer, J 23694, over seal and tap seal into place. Seal is seated when flush with housing.
6. Pack remaining grease in seat assembly and on seal.
-
Make sure inner surfaces of seats are liberally lubricated.
7. Position ball support yoke and cross assembly in flange yoke, aligning reference marks made at disassembly.
8. Install bearing cups.
-
Check the ball seat assembly. The ball support yoke should snap over center to the right or left and up or down freely if constant velocity joint
is correctly assembled.
