S10/T10 P/U 2WD V6-4.3L VIN W (1997)
5. Transmission from wiper motor drive link using J 39232
6. Wiper motor assembly from the vehicle.
Description
Description
Install or Connect
1. Wiper motor assembly to the vehicle with three screws.
Tighten
^
Wiper motor assembly mounting screws to 7 N.m (62 lbs. in.).
2. Drive link socket onto the crank arm ball of the wiper motor assembly using J 39529.
^
Lubricate the inside of the socket with white lithium grease (GM P/N 9985885) or equivalent.
IMPORTANT: Wiper transmission assembly must be assembled to the crank arm past the second detent so the seal is compressed to a maximum
height of 25 mm (1 inch).
3. Electrical connector.
4. Cowl vent screen and grille.
5. Wiper arm and blade assemblies.
6. Negative battery cable.
Inspect
