Silverado 1500 2WD V8-5.3L VIN B HO (2006)
1. Place the new detent lever/IMS assembly (4) in position in the transmission case. Rotate the detent lever/IMS assembly to engage the park pawl
apply assembly (2). Reinstall the manual shift shaft (5) through the manual shift shaft seal and through the detent lever/IMS assembly (4).
2. Push the manual shift shaft (5) into the final position in the transmission case.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the spherical pin (3) into the transmission case that retains the manual shift shaft.
4. Install the detent lever/IMS retaining bolt (1) using a T27 Torx(r) bit.
^
Tighten the bolt (1) to 10 Nm (92 inch lbs.).
5. Install the control valve assembly.