Silverado 1500 2WD V8-6.0L Hybrid (2009)
Note
The gray side tabs on the accessory dc power control module (APM) assembly connector (2) must be pressed in before rotating the lever.
20. Disconnect the APM assembly connector (2) using the following procedure:
1. Push the green tab.
2. Squeeze the gray side tabs, then rotate the lever.
21. Disconnect the APM assembly connector (3) using the following procedure:
1. Remove the locking tab.
2. Insert a small flat blade screwdriver into the locking tab area and raise the tab while pulling on the connector.
22. Disconnect the remaining APM assembly connector (1).
