chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Navigation Radio - Map Disc Read Error Message Displayed|Page 211 > < Navigation Radio - Map Disc Read Error Message Displayed
Page 2
background image

required.

1. Start the engine with the gear selector in PARK.
2. Wait until the Audio or Caution Screen is displayed after the opening screen has appeared.
3. Press the: NAV hard key.

Note
If the Caution Screen is displayed at Step 4 then follow the instruction, otherwise proceed to Step 5. 

4. Press the: I AGREE soft key.
5. Press the: MENU hard key.
6. Press the: NAV soft key.
7. Press the: MAP DATABASE INFORMATION soft key. 
8. Press the: CHANGE soft key. 
9. The navigation radio will automatically eject the map DVD. Remove the ejected disc.

Important
DO NOT put the disc in the top slot. DO NOT force the display to close. The display screen will remain in the open position until the
update is complete.

10. Load the update disc into the slot behind the display screen by inserting it partially until the system pulls it in. 

11. The screen: Preparing to Load System Software, will be displayed while the update is loading. The update should take approximately 4-6 minutes.

Observe the progress bar as it will indicate the progress of the update. 

12. AFTER the system restarts, press the: EJECT soft key to eject the software update disc. The disc may be used again on another vehicle.
13. Load the map DVD into the SAME slot located behind the display screen. DO NOT put it in the top slot. 
14. Press the: CLOSE soft key.
15. After the map screen is displayed, touch the map screen to confirm it can be scrolled. 

Important
The GPS location will start out in Washington DC and once learned, will show the correct location of the vehicle. Drive the vehicle to an
OUTDOOR location with an open view to the sky, away from any tall buildings.

16. Learning the GPS may take up to 10 minutes, depending on the vehicle's location. 
17. Ensure that the GPS signal has been received and the navigation map shows the correct location for the vehicle.
18. Verify that the Destination search area is properly displayed. 

1. Press the: DESTINATION hard key.
2. Press the: CHANGE SEARCH AREA soft key.
3. Select the: correct area for the vehicle's location.

Parts Information

Navigation software update discs are for the dealer to update the navigation radio software only. They DO NOT update or replace the navigation map
data that is supplied with the vehicle. Please order these parts only as needed. There is a limited supply of these discs available. Do not order these discs
for stock. Navigation software discs may be used to reprogram more than one vehicle. The first update disc for each P/N is free. Subsequent copies of the

Navigation Radio - Map Disc Read Error Message Displayed|Page 211 > < Navigation Radio - Map Disc Read Error Message Displayed