Silverado 1500 2WD V8-6.2L (2010)
1. Locate the chassis 12-way connector (1). The connector is located on the top of the driver's side shock tower. Refer to illustration.
2. Determine if the chassis 12-way connector is fully seated, connected and latched to the mating engine harness connector.
-
If the 12-way connector is properly connected, no further action is required.
-
If the 12-way connector is NOT properly connected, proceed to Step 3.
3. Carefully remove the 12-way connector from the shock tower.
4. Seat the 12-way connector face (2) as shown in illustration.
5. Reconnect the 12-way connector. Ensure that the connector is fully seated, connected and latched to the mating engine harness connector.
6. Re-install the 12-way connector on the shock tower.
Claim Information
1. Submit a claim using the table below.
2. Courtesy Transportation - For dealers using WINS, submit using normal labor code; for dealers using GWM - submit as Net Item under the repair
labor code.
Disclaimer