Silverado 1500 4WD V8-4.8L (2010)
Camshaft: Service and Repair
Camshaft Position Actuator Magnet Replacement
Camshaft Position Actuator Magnet Replacement
Removal Procedure
1. Remove the water pump. Refer to Water Pump Replacement (LU3) (See: Water Pump/Service and Repair)Water Pump Replacement (LMM) (
See: Water Pump/Service and Repair)Water Pump Replacement (V8) (See: Water Pump/Service and Repair).
2. Disconnect the engine harness electrical connector from the camshaft position (CMP) actuator magnet.
3. Remove the CMP actuator magnet bolts (751) and magnet (752).
4. Remove and discard the CMP actuator magnet gasket (753).
Installation Procedure
