Silverado 1500 4WD V8-5.3L VIN T (2004)
8. Install the fuel pipe bracket to the bellhousing stud.
9. Install the fuel pipe bracket nut.
Tighten
Tighten the nut to 10 N.m (89 lb in).
10. Lower the vehicle.
11. Remove the cap from the fuel rail.
12. Connect the fuel feed line (1) at the engine.
13. Connect the EVAP canister purge tube line (2).
14. Install the fuel fill cap.
15. Connect the negative battery cable.
16. Use the following procedure in order to inspect for leaks:
16.1. Turn the ignition ON, with the engine OFF, for 2 seconds.
16.2. Turn the ignition OFF for 10 seconds.
16.3. Turn the ignition ON, with the engine OFF.
16.4. Inspect for fuel leaks.
Evaporative Emission (EVAP) Hoses/Pipes Replacement - Chassis 2
EVAPORATIVE EMISSION (EVAP) HOSES/PIPES REPLACEMENT - CHASSIS
REMOVAL PROCEDURE
IMPORTANT: Clean all fuel pipe connections and surrounding areas before disconnecting the pipes in order to avoid possible fuel system
contamination.
