Silverado 1500 4WD V8-6.0L Hybrid (2009)
1. Apply sealant to the threads of the NEW oil pressure sensor. Refer to Adhesives, Fluids, Lubricants, and Sealers (See: Specifications/Adhesives,
Fluids, Lubricants, and Sealers) .
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution) .
2. Using J 41712 or equivalent, install the oil pressure sensor (706) and washer (707).
Tighten the sensor to 35 Nm (26 lb ft).
3. Connect the engine harness electrical connector (1) to the oil pressure sensor.
Tighten the sensor to 35 Nm (26 lb ft).
4. Install the intake manifold. Refer to Intake Manifold Replacement (Except LH6, LMG, LY5, L76, LY2, LY6) (See: Intake Manifold/Service and
Repair)Intake Manifold Replacement (LH6, LMG, LY5 and L76) (See: Intake Manifold/Service and Repair)Intake Manifold Replacement (LY2
and LY6) (See: Intake Manifold/Service and Repair) .