Silverado 1500 4WD V8-6.0L Hybrid (2009)
Wheel Fastener: Service and Repair
Rear Suspension
Wheel Stud Replacement
Tools Required
J 43631 Ball Joint Remover
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Vehicle Lifting/Service and Repair) .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Service and Repair) .
3. Remove the brake rotor. Refer to Rear Brake Rotor Replacement (JD9) (See: Brakes and Traction Control/Disc Brake System/Brake
Rotor/Disc/Service and Repair/Rear Brake Rotor Replacement (JD9))Rear Brake Rotor Replacement (JH6) (See: Brakes and Traction
Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Rear Brake Rotor Replacement (JH6))Rear Brake Rotor Replacement (JH7) (
See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Rear Brake Rotor Replacement (JH7)) .
4. Remove the wheel stud from the hub flange using the J 43631 .
5. Remove the wheel stud from the hub flange.
Installation Procedure
1. Install the new stud into the hub flange hole using firm hand pressure.
2. Install 4 washers to the new wheel stud.
3. Thread a wheel nut onto the new stud with the flat side facing the front hub flange .
4. Tighten the lug nut until the stud contacts the back of the hub flange.