Silverado 1500 4WD V8-6.0L VIN U (2006)
8. Install the VCIM screw (1) to the I/P.
Tighten the screws to 2 N.m (18 lb in).
9. Install the passenger side upper I/P bracket (2).
10. Install the I/P upper bracket screws (3).
Tighten the screws (3) to 2 N.m (18 lb in).
11. Install the I/P upper bracket screws (1).
Tighten the screws (1) to 50 N.m (37 lb ft).
12. Connect the coaxial cable (3) to the VCIM.
13. Connect the electrical connectors (2) to the VCIM.
14. Install the I/P trim panel.
15. Install the scan tool. Use the special functions menu in order to perform the OnStar(R) setup procedure for this vehicle.
IMPORTANT: After replacing the vehicle communication interface module, you must reconfigure the OnStar(R) system. Failure to reconfigure the