Silverado 1500 4WD V8-6.2L (2010)
2. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling (See: Procedures/Parking Brake Cable
Adjuster Disabling).
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
4. Disconnect the left park brake cable from the intermediate cable connector (1) by drilling a 3 mm (1/8 in) hole through the dimple in the
intermediate park brake cable connector.
5. Release the left park brake cable from the equalizer (3) by compressing the locking tabs on the cable conduit (2) and pulling the cable rearward.
6. Remove the park brake cable clip bolt.
7. Disconnect the park brake cable eye (1) from the park brake actuator lever (2).
8. Remove the park brake cable (3) from the bracket by pulling the cable conduit rearward to compress the spring and sliding the cable conduit out of
the bracket.
9. Remove the park brake cable assembly from the vehicle.
Installation Procedure
