Silverado 1500 4WD V8-6.2L (2010)
1. Install the park brake cable to the vehicle.
2. Install the brake shoes. Refer to Brake Shoe Replacement (See: Drum Brake System/Brake Shoe/Service and Repair).
Ensure the locking tabs on the cable conduit are fully engaged into the rear axle bracket.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the park brake cable clip bolt (2).
Tighten the bolt to 22 Nm (16 lb ft).
4. Connect the park brake cable (1) to the rear axle housing cover clip.
5. Install the park brake cable to the cable guides.