Silverado 1500 4WD V8-6.2L (2010)
Engine Mount: Service and Repair
Engine Mount Replacement
Engine Mount Replacement - Left Side
Engine Mount Replacement - Left Side (1500 Except RPOs LY6, LY2)
Removal Procedure
Caution: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Due to the
small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will
result in a damaged oil pickup unit.
1. If the vehicle is equipped with four wheel drive (4WD), remove the front drive axle. Refer to Differential Carrier Assembly Replacement (1500
FWD) (See: Transmission and Drivetrain/Differential Assembly/Service and Repair)Differential Carrier Assembly Replacement (2500 4WD) (
See: Transmission and Drivetrain/Differential Assembly/Service and Repair).
2. Lower the vehicle.
3. Remove the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side (Chevrolet) (See: Body and Frame/Fender/Front
Fender/Front Fender Liner/Service and Repair/Front Wheelhouse Liner Replacement - Left Side)Front Wheelhouse Liner Replacement - Left Side
(GMC) (See: Body and Frame/Fender/Front Fender/Front Fender Liner/Service and Repair/Front Wheelhouse Liner Replacement - Left Side).
4. Remove the engine mount to frame bolts (1).
5. Raise and support the vehicle halfway. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).