Silverado 1500 4WD V8-6.2L (2010)
12. Install the inner bearing.
Note: Ensure the seal is fully seated in the hub bore.
13. Using the J 44420 - installer (2) and the J 8092 - handle (1), install the new oil seal.
14. Apply a light coat of high melting point EP bearing lubricant to the axle housing spindle.
Note: If the rear axle hub assembly does not fully seat itself onto the axle shaft spindle and is removed, the rear axle hub seal must be replaced.
15. Install the rear axle hub.
Note: Install the rear wheel bearing adjuster nut by hand.
16. Using the J 2222-C - wrench , adjust the rear wheel bearings. Refer to Wheel Bearing Adjustment (See: Service and Repair/Procedures/Rear
Drive Axle/Wheel Bearing Adjustment) Wheel Bearing Adjustment