Silverado 2500 2WD V8-6.6L DSL Turbo (2010)
3. Using DT-48827 , remove the oil pressure sensor (1).
Installation Procedure
1. Apply sealant to the threads of the oil pressure sensor. Refer to Adhesives, Fluids, Lubricants, and Sealers (See: Specifications/Adhesives, Fluids,
Lubricants, and Sealers) for the correct part number.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Using DT-48827 , install the oil pressure sensor (1).
Tighten the sensor to 49 Nm (36 lb ft).
