Silverado 2500 2WD V8-8.1L VIN G (2005)
INSTALLATION PROCEDURE
1. Install the seat cushion cover to the foam pad.
2. Install the center screw retaining the latch cover, if removed.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screw to 2 N.m (18 lb in).
3. Engage the hook, and the loop-strips that are retaining the seat cushion cover (3) to the foam pad (4).
4. Install the seat buckles, if removed.
5. Connect the rear heater connector, if equipped.
6. Install the hog rings, and/or the J-clips in order to retain the seat cushion cover to the seat cushion frame (8).
7. Install the rear passenger seat risers.
8. Install the rear seat to the vehicle.
Seat Cushion Trim Cover and Pad Replacement
SEAT CUSHION TRIM COVER AND PAD REPLACEMENT
REMOVAL PROCEDURE
1. Remove the front nuts (2) on the underside of the seat cushion.
2. Remove the front seat trim panel.
3. Unsnap the lumbar cable (6). Disconnect the lumbar wire harness if equipped with power lumbar.
4. Disconnect the electrical connectors.
