Silverado 2500 2WD V8-8.1L VIN G (2005)
1. Install the cable support bracket.
2. Install the cable support bracket nuts.
Tighten the support bracket nuts to 85 Nm (64 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the rear cables to the mounting bracket by inserting the cable till all the retaining tabs snap into place.
4. Connect the rear cables to the equalizer.
5. Tighten the nut to the intermediate cable at the equalizer.
Tighten the nut to 3.5 Nm (31 inch lbs.).
6. Remove the safety stands.
7. Lower the vehicle.
Guide Replacement
Park Brake Cable Guide Replacement
Removal Procedure
1. Release the parking brake.
2. Raise and support the vehicle.
3. Remove the park brake cable guide bolt from the frame.
4. Remove the park brake cable guide.
5. Remove the park brake guide from the park brake cable.