Silverado 2500 2WD V8-8.1L VIN G (2005)
Valve Cover: Service and Repair
Valve Rocker Arm Cover Replacement (Left)
Valve Rocker Arm Cover Replacement - Left
Removal Procedure
1. Remove the engine sight shield.
2. Remove the connector position assurance (CPA) retainer from the ignition coil electrical connector.
3. Disconnect the ignition coil harness electrical connector (4).
4. Important: Twist the spark plug boot one-half turn in order to release the boot. Pull on the spark plug boot only. Do not pull on the spark plug
wire or the wire could be damaged.
Remove the spark plug wires from the spark plugs and ignition coils.
5. Remove the valve rocker arm cover bolts.
6. Remove the valve rocker arm cover.
Important: Valve rocker arm cover gaskets are reusable. Replace the gasket only if damaged.
7. Inspect the valve rocker arm cover gasket for cuts or damage.
8. Clean and inspect the valve rocker arm cover.