Silverado 2500 2WD V8-8.1L VIN G (2005)
Installation Procedure
1. Install the engine mount bracket onto the frame.
2. Perform the following procedure prior to installing the engine mount bracket bolts.
^
Remove all traces of the original adhesive patch.
^
Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
^
Apply threadlocker GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the bolts.
3. Loosely install the engine mount bracket through bolts.
4. Position the engine mount to engine.
5. Loosely install the engine mount-to-engine bolts.
6. Notice: Refer to Fastener Notice in Service Precautions.
Tighten the engine mount bracket through bolts and engine mount-to-engine bolts.
^
Tighten the engine mount bracket through bolts to 75 Nm (55 ft. lbs.).
^
Tighten the engine mount-to-engine bolts to 50 Nm (37 ft. lbs.).
7. Install the engine shield and bolts.
Tighten the engine shield bolts to 20 Nm (15 ft. lbs.).
8. Lower the engine.