Silverado 2500 2WD V8-8.1L VIN G (2005)
27. Connect the engine harness clip to the wheelhouse splash shield.
28. Connect the engine harness clips to the studs on the front of dash.
29. Connect the fuel feed and return pipes.
30. Install the sight shield bracket and nuts (1).
Tighten the nuts to 5 Nm (44 inch lbs.).
31. Install the sight shield to the bracket.
32. Snap the intake manifold sight shield to the stud.
33. Install the air cleaner outlet duct.
34. Tighten the clamps at the throttle body and air cleaner.
Tighten the clamps to 4 Nm (35 inch lbs.).
