Silverado 2500 2WD V8-8.1L VIN G (2005)
10. Remove the condenser from the vehicle.
INSTALLATION PROCEDURE
IMPORTANT: If replacing the condenser, add the refrigerant oil to the condenser. Refer to Refrigerant System Capacities for system capacity
information.
1. Install the condenser to the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the upper insulator retainers and the insulator retainer bolts.
Tighten
Tighten the bolts to 2.4 N.m (21 lb in).
3. Connect the evaporator tube to the condenser using new sealing washers.
4. Install the evaporator tube nut to the condenser.
Tighten
Tighten the evaporator tube nut to 16 N.m (12 lb ft).
5. Connect the compressor discharge hose to the condenser using new sealing washers.
6. Install the compressor discharge hose nut to the condenser
Tighten