Silverado 2500 2WD V8-8.1L VIN G (2005)
Center Mounted Brake Lamp: Service and Repair
HIGH MOUNTED STOP LAMP REPLACEMENT
REMOVAL PROCEDURE
1. Ensure the headlamp switch is in the OFF position.
2. Remove the high mounted stop lamp screws.
3. Remove the high mounted stop lamp from the vehicle.
4. Disconnect the electrical connector.
INSTALLATION PROCEDURE
1. Connect the electrical connector.
2. Install the high mounted stop lamp to the vehicle.
3. Install the high mounted stop lamp screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the high mounted stop lamp screws to 2 N.m (17 lb in).
4. Inspect the operation.