Silverado 2500 2WD V8-8.1L VIN G (2005)
1. Reinstall the magnet (2) onto the filter attachment tube (1) which is in the converter housing.
2. Lubricate the gasket (3) on the control main filter with transmission fluid.
3. Install, by hand, the control main filter (4) until the gasket on the control main filter touches the converter housing.
4. Notice: Turning the control-main filter more than ONE FULL TURN after gasket contact will damage the filter and may cause fluid leakage.
Turn the filter ONE FULL TURN ONLY after gasket contact.
5. Notice: Refer to Fastener Notice in Service Precautions.
Reinstall the drain plug (6) and drain plug seal (5).
^
Tighten the drain plug to 35 Nm (26 ft. lbs.).
6. Refill Transmission with DEXRON(R)III Automatic Transmission Fluid. Refer to Fluid Capacity Specifications.
7. Important: DTC P0701 may often set following fluid service. Cycling the ignition clears the code and allows Drive or Reverse range to be
attained.
Cycle the ignition until Drive or Reverse range is attained.
8. Important: Fluid remains in the external circuits and transmission cavities after draining the transmission.
Check the transmission fluid level.
