Silverado 2500 2WD V8-8.1L VIN G (2005)
Knee Diverter: Service and Repair
KNEE BOLSTER REPLACEMENT
REMOVAL PROCEDURE
1. Remove the I/P cluster trim plate bezel.
2. Remove the knee bolster screws.
3. Unsnap the top of the knee bolster from the I/P assembly.
INSTALLATION PROCEDURE
1. Snap the top of the knee bolster into the I/P assembly.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the knee bolster screws.
Tighten the screws to 2 N.m (18 lb in).
3. Install the I/P cluster trim plate bezel.