Silverado 2500 2WD V8-8.1L VIN G (2005)
Clutch Master Cylinder: Service and Repair
Clutch Master Cylinder Replacement
Removal Procedure
1. Disconnect the clutch pedal position switch electrical connector (1).
2. Push the clutch pedal in and squeeze the pushrod bushing tabs in, in order to release the pushrod bushing from the clutch pedal.
3. If equipped with a NV 3500 or NV 4500 transmission, disconnect the clutch actuator cylinder to clutch master cylinder quick connect fitting.
4. Remove the clutch master cylinder clip from the brake pressure module valve pipe.
5. If equipped with a ZF S6-650 transmission, disconnect the clutch actuator cylinder to clutch master cylinder quick connect fitting.
6. Rotate the clutch master cylinder 45 degrees clockwise to the unlocked position.