Silverado 3500 2WD V8-6.0L (2007)
8. Measure the amount of torque required to rotate the pinion. Use an inch-pound torque wrench. Record this measurement for reassembly. This will
give the combined preload for the following components:
*
The pinion bearings
*
The pinion pilot bearing (10.5 inch axle)
*
The pinion oil seal
*
The differential case bearings
*
The axle bearings (8.6 inch, 9.5 inch axles)
*
The axle seals (8.6 inch, 9.5 inch axles)
9. Place an alignment mark between the pinion and the pinion yoke.
10. Install the J 8614-01 as shown.
11. Remove the pinion nut while holding the J 8614-01.
12. Remove the washer.