Silverado 3500 2WD V8-8.1L VIN G (2005)
Parking Brake Actuator: Service and Repair
Park Brake Actuator Replacement (1500 Series w/Rear Disc)
Caution: Refer to Brake Dust Caution in Service Precautions.
Removal Procedure
1. Release the park brake.
2. Raise and support the vehicle.
3. Remove the tire and wheel assembly.
4. Relieve the tension from the park brake cables from the equalizer by pulling down on the intermediate cable and release the rear cables from the
equalizer bar.
5. Remove the rear park brake cable from the park brake actuator lever.
6. For vehicles without RPO NYS, remove the park brake cable from the mounting bracket by depressing the locking tabs.
7. For vehicles with RPO NYS, remove the rear park brake bracket bolt.
8. Remove the rotor.
9. Remove the axle shaft.
10. Remove the park brake shoe.
11. Remove the backing plate bolts.
12. Remove the park brake actuator lever housing from the backing plate.
Installation Procedure
1. Install the park brake actuator lever housing to the backing plate.