Silverado 3500 4WD V8-6.0L (2007)
4. Remove the transmission cover bolt.
5. Remove the starter bolts.
6. Disconnect the engine wiring harness electrical connector (4) from the oil level sensor.
Notice: Avoid cable and wiring damage. DO NOT suspend the starter by the cables or wires attached to the solenoid terminals. Use a rope or
mechanics wire to suspend the starter.
7. Slide the starter forward until the starter clears the transmission and properly support the starter.
8. Lower the vehicle half way.
9. Remove the right front wheel and tire.
10. Remove the right front wheelhouse liner.
