Silverado Classic 1500 2WD V6-4.3L (2007)
Engine Oil Dip Stick - Dip Stick Tube: Service and Repair
Oil Level Indicator and Tube Replacement
Removal Procedure
1. Remove the oil level indicator.
2. Remove the right exhaust manifold.
3. Remove the oil level indicator tube bolt.
4. Remove the oil level indicator tube using a twisting motion.
5. Clean the old sealer from the indicator tube and engine block.
Installation Procedure
1. Apply sealant around the indicator tube 13 mm (0.5 inch) below the tube bead. Refer to Sealers, Adhesives, and Lubricants for the correct part
number.
2. Install the indicator tube. Rotate the oil level indicator tube into position.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the indicator tube bolt.
Tighten the bolt to 12 Nm (106 inch lbs.).
