Silverado Classic 1500 4WD V8-4.8L (2007)
1. Install the relay rod (9) to the vehicle.
2. Install the relay rod (9) to the pitman arm ball stud (2).
3. Install the relay rod (9) to the idler arm ball stud (1).
4. Ensure the seal is on the stud.
5. Install the J 29193 or the J 29194.
6. Notice:
Refer to Fastener Notice.
Tighten the steering linkage installer in order to seat the tapers.
Tighten the steering linkage installer to 54 Nm (40 ft. lbs.).
7. Remove the J 29193 or the J 29194.
8. Install the new pitman arm prevailing torque nut.
9. Install the new idler arm prevailing torque nut.
Tighten the nuts to 62 Nm (46 ft. lbs.).
10. Install the tie rod ends.
11. Install the steering damper to the relay rod, if equipped. Refer to Steering Linkage Shock Absorber Replacement.
12. Install the engine protection shield, if equipped.
13. Lower the vehicle.
14. Check the wheel alignment. Refer to Measuring Wheel Alignment.
