Silverado Classic 1500 4WD V8-4.8L (2007)
Wheel Fastener: Service and Repair
Front Suspension
Wheel Stud Replacement
Tools Required
^
J 43631 Ball Joint Remover
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the brake rotor. Refer to Front Brake Rotor Replacement (1500 Series) Front Brake Rotor Replacement (25/3500 Series).
4. Remove the wheel stud from the hub flange using the J 43631.
5. Remove the wheel stud from the hub flange.
Installation Procedure
1. Install the new stud into the hub flange hole using firm hand pressure.
2. Install 4 washers to the new wheel stud.
3. Thread a wheel nut onto the new stud with the flat side facing the front hub flange.
4. Tighten the lug nut until the stud contacts the back of the hub flange.
5. Remove the wheel nut.
6. Remove the washers.
7. Install the brake rotor.
8. Install the tire and wheel.
9. Remove the safety stands.
10. Lower the vehicle.
