Silverado Classic 1500 4WD V8-5.3L Hybrid (2007)
1. Install the wheel cylinder.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the wheel cylinder bolts.
Tighten the bolts to 18 Nm (13 ft. lbs.).
3. Remove the plug or cap from the brake line fitting.
4. Connect the brake line to the wheel cylinder.
Tighten the fitting to 19 Nm (14 ft. lbs.).
5. Install the rear brake shoes.
6. Bleed the brake system. Refer to Hydraulic Brake System Bleeding (Manual).
7. Check the master cylinder fluid level, add fluid if necessary. Refer Master Cylinder Reservoir Filling.
