Silverado Classic 1500 4WD V8-5.3L Hybrid (2007)
Drive Motor Power Cable: Service and Repair
Generator Battery Positive and Negative Cable Replacement (5.3L Engine w/RPO HP2)
Generator Battery Positive and Negative Cable Replacement (5.3L Engine w/RPO HP2)
Removal Procedure
1. Remove the passenger side front fender.
2. Remove the generator control module (GCM).
3. Remove the GCM bracket nuts and bolt.
4. Remove the GCM bracket.
5. Remove the heating, ventilation and air conditioning (HVAC) module.
6. Remove the 42-volt positive/negative cable grommet nuts (1) from the front of dash.
7. Push the 42-volt positive/negative cable grommet through the front of dash.
8. Remove the hinge pillar trim.
9. Remove the 42-volt positive/negative cable clip (2) from at the right cowl panel.
10. Remove the door sill plate.
11. Reposition the carpet.
12. Remove the 42-volt positive/negative cable channel rear nut (3).
13. Disengage the 42-volt positive/negative cable channel from the studs on the floor.
14. Remove the 42-volt positive/negative cable retainer nuts, and retainer.
