Silverado Classic 1500 4WD V8-5.3L Hybrid (2007)
Battery Temperature Sensor: Service and Repair
Generator Battery Temperature Sensor Replacement
Caution: To help avoid personal injury, disable the 36V system anytime you perform service work on or around the generator battery carrier.
The 36V system will still be active after you have disabled the generator battery carrier.
Caution: To help avoid personal injury, always disconnect the 36V generator battery carrier before doing any work to the generator battery
carrier system. To disconnect the generator battery carrier, turn the engine off and turn OFF the service disconnect switch, which is located on
the passenger side of the generator battery carrier.
Removal Procedure
1. Remove the generator battery carrier intermediate cover.
2. Remove the tie strap.
3. Disconnect the temperature sensor electrical connector.
4. Remove the temperature sensor screw (1).
5. Remove the temperature sensor (2) from the generator battery carrier battery.
Installation Procedure
1. Install the temperature sensor (2) to the generator battery carrier battery.
Notice: Refer to Fastener Notice.
2. Install the temperature sensor screw (1).
Tighten the screw to 0.5 N.m (4.4 lb in).
