Silverado Classic 3500 4WD V8-6.6L DSL Turbo (2007)
steering gear inlet line connection at the gear.
6. Remove the engine protection shield.
7. Install a drain pan under the vehicle.
8. Notice:
Refer to Power Steering Hose Disconnected Notice.
Remove the brake booster inlet clamp bolt from the frame rail.
9. Remove the power steering gear inlet hose from the power steering gear.
10. Lower the vehicle.
11. Remove the power steering gear inlet hose (1) from the brake booster.
12. Remove the power steering gear inlet hose from the vehicle.
Installation Procedure
1. Notice:
Refer to Installing Hoses without Twists or Bends Notice.
Route the hose in the same position the hose occupied prior to removal.
2. Install the power steering gear inlet hose (1) to the brake booster (2). Hand tighten only.
3. Raise the vehicle.
4. Notice:
Refer to Fastener Notice.
Install the power steering gear inlet hose (1) to the power steering gear (3) through the wheel well.
Tighten the power steering gear inlet hose fitting to 28 Nm (21 ft. lbs.).
5. Install the power steering gear inlet hose clamp bolt to the frame rail.
Tighten the power steering gear inlet hose clamp to 12 Nm (9 ft. lbs.).
6. Install the engine protection shield.
